236 replies to this topic

[Jdtirado]

I always figured that going to the proper thread makes sense, so wrapping this up would just make us do another thread on this. If this happens, the experience and pages from the previous input is lost.I wonder what thread has had the most pages in the history of Brew-Bros?

Edited by Jdtirado, 05 June 2012 - 10:40 AM.

[brewman]

Right now Im sanding and cleaning my slits. Trying to get all the copper shavings out of it before I brew this weekend.and im doing it naked.Just think, Dan naked cleaning his slits.Dan

[Mynameisluka]

I wonder what thread has had the most pages in the history of Brew-Bros?

it's in the ph. there's a gif thread...that has the most pages, then there's a joke thread with the second most (i believe), and then a thread that can no longer be found about zimmerman that has the third most.

[Deerslyr]

it's in the ph. there's a gif thread...that has the most pages, then there's a joke thread with the second most (i believe), and then a thread that can no longer be found about zimmerman that has the third most.

The gif thread though is the standard. The joke thread merged several joke threads into one and almost overnight it was a Mega-Thread.But as for the Beer Forum... hmmm... not sure, but i'm guessing around 20 pages.

[Mynameisluka]

largest threads in the beer forum.https://www.brews-br...s__sort_by__Z-A

[Mynameisluka]

this thread is actually close to the top...

[brewman]

It will be on top soon as people find out Im sanding my slits nakedDan

[Mynameisluka]

It will be on top soon as people find out Im sanding my slits nakedDan

watch out for flying copper shavings..dont wanna get those in the wrong place.

[Deerslyr]

this thread is actually close to the top...

Huh... who knew!? I bet if we start a thread in the Beer Forum titled "Beer Is Proof That God Loves Us", we could easily hit 20 pages before it gets locked.

[Mynameisluka]

lol

[brewman]

All the slits are now clean and burr free. Now its time for a deep cleaning.Dan

[Hines]

All the slits are now clean and burr free. Now its time for a deep cleaning.Dan

Clean your mashtun when you are done with YOUR deep cleaning too.

[brewman]

Yea its full of copper dust.dan

[Jdtirado]

I was going to start cutting off some copper pipe today to fit this cooler, but wanted to know first if this hump covering the front wheel would pose a draining problem and make this a no go?httpss://lh4.googleusercontent.com/-wvJyPVhf9mU/T9H5Y9FOa7I/AAAAAAAAAfE/R6tqWe-XSRY/s700/Cooler.JPG

[brewman]

If your manifold is on the bottom of the cooler and you put a nipple on your valve with a hose that goes lower then the manifold then you will get most of the liquid out of the tun. When I made mine I made sure to solder the connections taht were higher then the manifold so it wouldnt suck air when they were out of the liquid.Dan

[Jdtirado]

When I made mine I made sure to solder the connections taht were higher then the manifold so it wouldnt suck air when they were out of the liquid.Dan

Gotcha, makes sense. Thanks. Tell me again how you got the burrs off the slits?

[brewman]

I used a wire brush that had like a ball of wires at the end for the inside and sandpaper for the outside.Dan