7/16 inch insert to 3/8 inch kingpin
Started by
cbbrown40
, Apr 22 2009 08:14 AM
3 replies to this topic
#1
Posted 22 April 2009 - 08:14 AM
Quite some time ago I purchased these inserts for my Brutus Ten stand along with some casters from a different place. The inserts are 7/16 and are the one in the link below. My casters kingpins are 3/8 inch any ideas on a way to make them work together. I thought I might be able to find some sort of threaded insert to adapt but no luck so far. Any Ideas ?Threaded insert
#2
Posted 22 April 2009 - 08:43 AM
actually it is a 1/2 inch insertQuite some time ago I purchased these inserts for my Brutus Ten stand along with some casters from a different place. The inserts are 7/16 and are the one in the link below. My casters kingpins are 3/8 inch any ideas on a way to make them work together. I thought I might be able to find some sort of threaded insert to adapt but no luck so far. Any Ideas ?Threaded insert
#3
Posted 22 April 2009 - 08:50 AM
Install a heli-coil?MB
#4
Posted 23 April 2009 - 04:41 PM
1.) Buy four 1/2" bolts of appropriate length.2.) Drill out the center of bolts with 29/64" bit.3.) Tap with 7/16" tap.4.) Cut heads off bolts.5.) Put pieces together.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users