I was looking through my grain from Sunday and I see more full kernels than I like. My mill is set as tight as it will go so I guess the only option is to double mill at this point.
Posted 27 January 2021 - 06:44 AM
I was looking through my grain from Sunday and I see more full kernels than I like. My mill is set as tight as it will go so I guess the only option is to double mill at this point.
Posted 27 January 2021 - 07:47 AM
what mill is it again? I'm surprised that the tightest setting doesn't do it!
Posted 27 January 2021 - 07:59 AM
It is a JSP Malt Mill http://schmidling.com/barebone.htm
The issue may be that it is only adjustable on one side. So you have a triangle opening vs the rollers being perfectly parallel.
I dump my grain out back and in the past after a few days I notice that I can see large pieces in there as it dries out so this is not new but at this point I need to address it somehow. Either double mill, not overly thrilled at that idea or a new mill.
Posted 27 January 2021 - 08:06 AM
Posted 27 January 2021 - 08:16 AM
Only adjustable on one end, that seems like a silly design.
I agree. 15-18 years ago when I got this my options were limited and this was the best option at the time. I know Denny has the same mill and does not seem to have an issue but I am not sure if his is single sided or both side adjustable.
Posted 27 January 2021 - 08:56 AM
Only adjustable on one end, that seems like a silly design.
Posted 27 January 2021 - 09:26 AM
Yeah, that means you can never get an even crush. I think you've earned a new mill!
I think I will open it to .035 and double mill and see how it goes. If I still notice issues I will start some mill research.
I think I am a week or 2 out from my next batch.
Posted 07 February 2021 - 10:03 AM
Posted 07 February 2021 - 10:09 AM
Posted 07 February 2021 - 10:37 AM
Posted 07 February 2021 - 04:13 PM
Only adjustable on one end, that seems like a silly design.
It didn't take me long to buy parts to make both sides adjustable. That worked well until it wore out.
0 members, 0 guests, 0 anonymous users